Tdizzy shows us how to paint a rc car body with spray cans. All the supplies in this video were purchased at HobbyTown. flame mask – www.xtownrc.com www.rcracingusa.net The tool that you will need for this How To: 1. Liquid soap 2. Water 3. A pencil 4. A clean towel 5. Masking tape Use fresh tape 6. Xacto knife 7. Lexan paint 8. Permanent marker 9. Denatured alcohol (You can get this at any hardware store, usually in the paint section). 10. Steel wool, wet sanding paper, or a scotch brite pad 11. Unpainted Lexan body When you have all these tools you are ready to begin. Prepare the body for paint Wash the inside of the body with liquid soap and water. Then rinse off all the soap, and dry completely with a clean towel. Find the window masks that came with your shell and stick them on the inside of the body using the window lines as reference points. Firmly press down on the edges of the window masks with your finger nails to ensure no bleeding of the paint. Once the windows are masked off take the steel wool, fine wet sandpaper or scotch brite padand scuff the inside of the body until it becomes cloudy. This step will help ensure that the paint adheres to the body and wont be noticed after the body is painted. (If you are using chrome paint do not include this step, this will cause the chrome to have a brushed finish). Drawing the Design Draw the design on the outside of the body using the permanent marker, and place a strip of tape on the inside of the body over the area …